BatteryMINDer Airframe Interface Kit

    • Item #14920
    • PN: BM-AIK2A
  • In Stock
  • Item #14920
Qty

The BatteryMINDer is a cutting-edge aviation battery charger, maintainer, and desulfator. Designed for all aviation-specific FAA Certified Concorde, Gill, Hawker, and Odyssey brand batteries including Sealed, Wet (filler cap), Maintenance-Free, AGM, Gel, and PLT thin-plate lead-acid types.

It's equipped with an efficient design, controlled by industrially-rated microprocessors, allowing for continuous operation (24hrs/day) without the fear of over/undercharging. Temperature sensors further enhance this feature, preventing over/undercharging from freezing to 130F.

One of the most advanced in the market, this unit offers users the ability to determine the level of charge remaining in their battery, identify if it's weak and in need of replacement before going bad. It tests for weak/dead cells and is capable of recovering weak or severely discharged batteries that other chargers would reject.

Experience advancements in battery analysis and condition assessment not previously available in any other single model. Run your aviation operations with peace of mind, knowing that your batteries are in the safest, most capable hands.

  • Guaranteed to never overcharge/undercharge. (33°F to 130°F)
  • Tested and endorsed by leading battery makers.
  • 100% Full-Time U.S. Patented Pulse-type Desulfation keeps battery free of sulfate or dissolves sulfate completely in older batteries.
  • etects and rejects batteries with bad cells. Terminate charge to prevent out-gassing.
  • Maximize battery life and capacity, recovers weak batteries.
  • Diagnoses battery’s condition / state-of-charge.
  • Recovers weak or deeply discharged batteries: including but not limited to flooded filler cap, maintenance-free, valve regulated lead-acid (VRLA), sealed lead-acid (SLA), starter, deep cycle and hybrid.
  • Maintain up to 2 batteries at a time. (requires BatteryMINDer Y-Connector Accessory 210-AY)
  • Auto-Restart after power failure.
  • Bad cell detection with auto-shutdown.
  • Includes Short circuit, spark, reverse polarity protection, thermal runaway protection, automatic D/C disconnect on A/C failure and quick-connect/disconnect fused alligator clip assembly.
  • Very high efficiency. California CEC Approved. Certified to California Energy Commission Standards.
  • Automatically detects input AC power.
  • ECO-mode with hi-efficiency / low power consumption. This allows the unit to always remain connected to AC while consuming very low level of electricity.
  • Ambient temperature compensation. Built-in temperature sensor automatically adjusts charge rate to ensure full-charge. (as low as 0°F or as high as 130°F)
  • 12 LED indicators show state-of-charge and important status mode / battery condition.
  • Rugged, vibration-resistant construction.
  • Never connect two or more batteries together before fully charging each and checking their condition. Failure to fully charge each battery and check their condition can result in a serious safety hazard.

Seven stages of battery charging

  1. Analyze: test and accept/reject battery
  2. Desulfate: begins removal by dissolving harmful sulfate
  3. Soft start: applies low current if battery tests low
  4. Bulk: provides maximum output to charge to 85%
  5. Absorption: provides low current to complete to 100%
  6. Test: to determine if the battery needs further desulfation
  7. Maintenance: maintains temperature-compensated full charge

 

What's included with your BatteryMINDer?

  • Model 128CEC2-AA-S5 Charger-Maintainer-Desulfator
  • 6' AC cord, 6' DC cord with quick connector (SAE)
  • Auto-Temp Compensation Sensor (Installed)
  • 2' Insulated Battery Clip Cord Set with Quick Connector and 15A replaceable fuse

Choose one of these options above for either 12 volt or 24 volt electrical systems:

  1. 12 Volt for Gill Batteries (128CEC2-AA-S2) (see note below)
  2. 12 Volt for Hawker / Odyssey Batteries (128CEC2-AA-S3)
  3. 12 Volt for Concorde Batteries (128CEC2-AA-S5)
  4. 24 Volt for Gill Batteries (244CEC2-AA-S2)  (see note below)
  5. 24 Volt for Hawker / Odyssey Batteries (244CEC2-AA-S3)
  6. 24 Volt for Concorde Batteries (244CEC2-AA-S5)

NOTE:  If you have a Gill LT 7000 series battery, you should get the model for Hawker / Odyssey instead of the Gill.  Order the Gill version for all other Gill batteries.

Lowest Price Guaranteed!

If you find a better price elsewhere on this product we will Match that price and beat it by 10% of the difference. See Details.

Buy with Confidence!

Purchase today and you can return it in the original condition through Sunday, October 13, 2024 ! See our return policy.

BatteryMINDer Airframe Interface Kit

  • In Stock
  • Item #14920
  • PN: BM-AIK2A
Qty

BatteryMINDer Airframe Interface Kit Overview:

The BatteryMINDer is a cutting-edge aviation battery charger, maintainer, and desulfator. Designed for all aviation-specific FAA Certified Concorde, Gill, Hawker, and Odyssey brand batteries including Sealed, Wet (filler cap), Maintenance-Free, AGM, Gel, and PLT thin-plate lead-acid types.

It's equipped with an efficient design, controlled by industrially-rated microprocessors, allowing for continuous operation (24hrs/day) without the fear of over/undercharging. Temperature sensors further enhance this feature, preventing over/undercharging from freezing to 130F.

One of the most advanced in the market, this unit offers users the ability to determine the level of charge remaining in their battery, identify if it's weak and in need of replacement before going bad. It tests for weak/dead cells and is capable of recovering weak or severely discharged batteries that other chargers would reject.

Experience advancements in battery analysis and condition assessment not previously available in any other single model. Run your aviation operations with peace of mind, knowing that your batteries are in the safest, most capable hands.

  • Guaranteed to never overcharge/undercharge. (33°F to 130°F)
  • Tested and endorsed by leading battery makers.
  • 100% Full-Time U.S. Patented Pulse-type Desulfation keeps battery free of sulfate or dissolves sulfate completely in older batteries.
  • etects and rejects batteries with bad cells. Terminate charge to prevent out-gassing.
  • Maximize battery life and capacity, recovers weak batteries.
  • Diagnoses battery’s condition / state-of-charge.
  • Recovers weak or deeply discharged batteries: including but not limited to flooded filler cap, maintenance-free, valve regulated lead-acid (VRLA), sealed lead-acid (SLA), starter, deep cycle and hybrid.
  • Maintain up to 2 batteries at a time. (requires BatteryMINDer Y-Connector Accessory 210-AY)
  • Auto-Restart after power failure.
  • Bad cell detection with auto-shutdown.
  • Includes Short circuit, spark, reverse polarity protection, thermal runaway protection, automatic D/C disconnect on A/C failure and quick-connect/disconnect fused alligator clip assembly.
  • Very high efficiency. California CEC Approved. Certified to California Energy Commission Standards.
  • Automatically detects input AC power.
  • ECO-mode with hi-efficiency / low power consumption. This allows the unit to always remain connected to AC while consuming very low level of electricity.
  • Ambient temperature compensation. Built-in temperature sensor automatically adjusts charge rate to ensure full-charge. (as low as 0°F or as high as 130°F)
  • 12 LED indicators show state-of-charge and important status mode / battery condition.
  • Rugged, vibration-resistant construction.
  • Never connect two or more batteries together before fully charging each and checking their condition. Failure to fully charge each battery and check their condition can result in a serious safety hazard.

Seven stages of battery charging

  1. Analyze: test and accept/reject battery
  2. Desulfate: begins removal by dissolving harmful sulfate
  3. Soft start: applies low current if battery tests low
  4. Bulk: provides maximum output to charge to 85%
  5. Absorption: provides low current to complete to 100%
  6. Test: to determine if the battery needs further desulfation
  7. Maintenance: maintains temperature-compensated full charge

 

What's included with your BatteryMINDer?

  • Model 128CEC2-AA-S5 Charger-Maintainer-Desulfator
  • 6' AC cord, 6' DC cord with quick connector (SAE)
  • Auto-Temp Compensation Sensor (Installed)
  • 2' Insulated Battery Clip Cord Set with Quick Connector and 15A replaceable fuse

Choose one of these options above for either 12 volt or 24 volt electrical systems:

  1. 12 Volt for Gill Batteries (128CEC2-AA-S2) (see note below)
  2. 12 Volt for Hawker / Odyssey Batteries (128CEC2-AA-S3)
  3. 12 Volt for Concorde Batteries (128CEC2-AA-S5)
  4. 24 Volt for Gill Batteries (244CEC2-AA-S2)  (see note below)
  5. 24 Volt for Hawker / Odyssey Batteries (244CEC2-AA-S3)
  6. 24 Volt for Concorde Batteries (244CEC2-AA-S5)

NOTE:  If you have a Gill LT 7000 series battery, you should get the model for Hawker / Odyssey instead of the Gill.  Order the Gill version for all other Gill batteries.

 

0 CUSTOMER REVIEWS

0 QUESTIONS & ANSWERS

Customers who bought this also considered:

Lowest Price Guaranteed!

If you find a better price elsewhere on this product we will match that price and beat it by 10% of the difference.

Buy with Confidence!

Purchase today and you can return it in the original condition through Sunday, October 13, 2024 !  See our return policy.

Sign up for our newsletter and stay updated on special offers.